图片
免费，登录即可下载
发布时间：2021/1/7 22:37:00
Quick edit of a standard 5x6 dactyl manuform
Added a bit of extra height to the case to allow for easier hand wiring
Created a bottom plate that friction fits in, but still has optio to use screws, recommend m3x8mm and m3 threaded ierts
usb-c cutout on the back is designed for this dongle:
Didn't design any teey holde in this case, didn't seem like it was necessary with the extra height of the case.
Will update this with more pictures as my build progresses
Printer used is a prusa mini , prints flat with supports
Added a bit of extra height to the case to allow for easier hand wiring
Created a bottom plate that friction fits in, but still has optio to use screws, recommend m3x8mm and m3 threaded ierts
usb-c cutout on the back is designed for this dongle:
Didn't design any teey holde in this case, didn't seem like it was necessary with the extra height of the case.
Will update this with more pictures as my build progresses
Printer used is a prusa mini , prints flat with supports
|
共0个文件
压缩包大小：2MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付