图片
免费，登录即可下载
发布时间：2021/1/5 12:07:00
I did not really like the native hood of the Anycubic i3 MEGA hotend. Basically, the air ducts of the fa are quite ugly. They made a lot of noise when the air passes through them.
I decided to get rid of the metal casing and make this
For this modification, you will need:
4 M3 nuts
4 M3 * 12..16 screws
turbofan, for example:
or
2 screws for attaching it (such as used to mount a fan in a computer)
The casing is assembled using filament pieces that need to be ierted into the holes. Can be fixed with cyanoacrylate.
That's all. Now, by reducing the inertia of the head and better cooling the print zone, I can print at higher speeds.
16.02.2018 UPDATE:
Added grille front.
While print ABS it's to much air blows down the hotend and print delaminates.
Grille helps a little.
01.03.2018 UPDATE:
Please use this firmware mod to have 12V at FAN0 port OAND adjust output voltage of main power unit with VR to 13.5 volt.
Peace for everyone!
I decided to get rid of the metal casing and make this
For this modification, you will need:
4 M3 nuts
4 M3 * 12..16 screws
turbofan, for example:
or
2 screws for attaching it (such as used to mount a fan in a computer)
The casing is assembled using filament pieces that need to be ierted into the holes. Can be fixed with cyanoacrylate.
That's all. Now, by reducing the inertia of the head and better cooling the print zone, I can print at higher speeds.
16.02.2018 UPDATE:
Added grille front.
While print ABS it's to much air blows down the hotend and print delaminates.
Grille helps a little.
01.03.2018 UPDATE:
Please use this firmware mod to have 12V at FAN0 port OAND adjust output voltage of main power unit with VR to 13.5 volt.
Peace for everyone!
|
共0个文件
压缩包大小：2MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付