图片
免费，登录即可下载
发布时间：2021/1/3 9:30:00
I really liked this design, but it was just too big, even for my printer. I figured I could help out the original designer and make the slices I made in Meshmixer available to everyone.
Original file:
EDIT 06DEC2017: INFINITY TOWER: I cut the top into two additional files. Print as many Upper Windows as you want, rotating them 180 degrees to bounce the dice back and forth. Make the tower as tall as you want! Print the spires to top it off.
EDIT 05DEC2017: There were some erro with the files. I have repaired them in Netfab. I also repaired some of the triangles that made a few of the damaged windows unprintable without to of support. Hopefully, this will be an improvement.
Original file:
EDIT 06DEC2017: INFINITY TOWER: I cut the top into two additional files. Print as many Upper Windows as you want, rotating them 180 degrees to bounce the dice back and forth. Make the tower as tall as you want! Print the spires to top it off.
EDIT 05DEC2017: There were some erro with the files. I have repaired them in Netfab. I also repaired some of the triangles that made a few of the damaged windows unprintable without to of support. Hopefully, this will be an improvement.
|
共0个文件
压缩包大小：4MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付