无人机推进器护罩

2/9/2020 1600 So I finished printing the fourth one, got them italled, can while taking the picture of it in flight it went full speed in to the fence and destroyed the prop guards. I think they were to flimsy and threw off the gyros. I since removed that file, Tweaked my design printed and tested one (indoo) when I get all four printed and I get a test flight I will let u know.
My new drone (Poteic D58) freaked out on me when it reached low battery and tried to gps return to take off spot right in to a pepper tree. I managed to get it out with a 16' exteion ladder and two broom stickes zip tied together but it lost one of the propeller guards. So off to fusion 360. I uploaded two, the one in the photo I attached and lifted off in the living room but have not given it a true flight. I expect these to probably break every hard landing but not that big of a deal when I can print them in 20 min. I expect the other one which is more like the stock one will need supports, I have yet to print.
I may after giving them a good test flight if they hold up or just look better I may add some strength to them and print them in PLA I have that seems to be a little stronger.