柜子底下的玻璃架

STL 可转其他格式 ››

免费，登录即可下载

发布时间：2020/8/6 1:36:00

Had a specific requirement for a under shelf glass rack - so designed this. Design is 18cm long and has a straight run at the end that you can either leave to connect 2 together (for a deep cupboard), leave if its at the back of a cupboard (so nothing slips off) or snip off to access from either side.
No screw holes have been put in it - this was intentional so that I could put them in the best place for my shelf. Plastic is thin enough to screw straight through, drill through or if you're feeling brave and using command strips will hopefully stick well! (i really wouldn't use command strips if its holding glass!)
Under Cupbpard Stemmed Glass Rack (desman83) - 19/06/2020
Under Cupboard Stemmed Glass
Printer: Creality Ender 3
Rafts: No
Supports: No
Resoltuion: 0.2
Infill: 100%
Filament: Amazon Basic 1.75
Filament Colour: Traparent
Filament Material: PETG, although PLA would be fine
Designed With: TinkerCad
Sliced in: Ultimaker Cura 3d
Tip me? Thanks!
BTC Wallet: 1LDVHtDPcELFKr2Z6ygADbXAGNjCerTUNV