图片
免费，登录即可下载
发布时间：2021/1/12 9:40:00
EDIT: Issues should be fixed (5/5/20), but I haven't printed it yet. That's next.
Made a Wonder Woman shelf for my husband to display his Funko Pops. They’re big enough to hold one each. They print nice on their backs with no supports. Will post a picture when my test print is done.
They’re meant to be screwed into the wall with two screws, and there are plugs that hide the screw heads.
I’ve also made them into a set of six that have a Boolean that’ll hold his shield on the wall and display Pops. They’re labeled Left Top, Left Middle, Left Lower, Right Top, Right Middle, Right Lower. Will have pictures once they're printed and hung. :)
(Does not include shield.)
EDIT: This is a little off and needs a bit more work. There's not quite enough room for a pop to stand with the shield in there because their heads are so dang big. Will do some tweaking. (Alas, if you just print them a bit bigger, they'll print and all, but the boolean is too big for the shield to be held tight. Back to the drawing board.)
Made a Wonder Woman shelf for my husband to display his Funko Pops. They’re big enough to hold one each. They print nice on their backs with no supports. Will post a picture when my test print is done.
They’re meant to be screwed into the wall with two screws, and there are plugs that hide the screw heads.
I’ve also made them into a set of six that have a Boolean that’ll hold his shield on the wall and display Pops. They’re labeled Left Top, Left Middle, Left Lower, Right Top, Right Middle, Right Lower. Will have pictures once they're printed and hung. :)
(Does not include shield.)
EDIT: This is a little off and needs a bit more work. There's not quite enough room for a pop to stand with the shield in there because their heads are so dang big. Will do some tweaking. (Alas, if you just print them a bit bigger, they'll print and all, but the boolean is too big for the shield to be held tight. Back to the drawing board.)
|
共0个文件
压缩包大小：2MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付