这个remix是我重新使用LED灯的改造的延续在这种情况下,所有当事方都是可打印的,只需要增加一些部件: -8×8毫米脉冲波顿 -一个LED(不使用多个LED,因为它破坏了蝙蝠信号图像), -一点铜丝做接触到电池槽, -M3x15螺丝, -一点点电缆, -三个AAA电池 还需要把一个圆圈切割成薄膜才能用作玻璃在切之前,我建议你在塑料后面用手电筒做一个照明测试,看看有没有奇怪的影子,不是所有的塑料都有用。 蝙蝠信号的主要部位是Lehof设计的底座用来旋转反射器的底座和按钮都是我的设计除了Rustycracklford设计的电池板 为了使电池盒发挥作用,必须在其两端添加一些导电丝。我用了一毫米的铜线,但它可以使用普通的电缆或铝纸。 如果你想使用另一种电池或重新设计内部电池,我也在打印文件中列入了没有电池的基底模型。(只需要打印一个基地!) 至于支撑,它可以帮助它的顺利运行,只需要在两三个地方。 我希望能看到很多印刷的复制品我很喜欢设计它 This remix is a continuation of the modification I made to reuse an led lantern.在这种情况下,所有当事方都是可以接受的,只是增加了一些组成部分: -巴顿巴顿8x8mm, -A LED(Do not use more than one,because it distorts the image of the batifoco), -小铜无线公司在电池控股公司进行联络, -M3x15 Screw, -小电缆, -3 AAA Batteries. 它还需要在某些工作场所进行整形手术,以便使用玻璃。I recommend that you do the test to light behind the plastic that you are going to use and check that rare shadows are not generated,not all plastics are useful. The main body of the batsignal is the one designed by Lehof,the base with the system to旋转the reflector and the Button are completely my desig except for the silhouette of the battery holder that is the design of rustycrackleford. For the battery holder to be functional,you have to add some conductive wire at its ends.I used 1mm copper wire,but a common wire or foil can be used. i also included among the print files the base model without the battery holder,in case you prefer to use another type of battery or redegen the inside.(You only need to print a single base!) About the supports,it helps that it goes well,it is only necessary in two or three places. I hope to see many printed replicas,I really enjoyed designing it.