图片
免费，登录即可下载
发布时间：2021/1/23 21:12:00
I stole someone's falcon and modified it, but for the life of me I can't figure out who the original creator of this falcon was. Sorry guys - newb here.
Print the control Knob upside down without supports. If you make supports getting them out of the center is nearly impossible. 100% infill - .15 layer height
Print the falcon separately with supports. Print it pointing up with a large brim (at least 5 mm). I used Slicr prusa edition and set the supports to 0 for auto. 100% infill - .15 layer height
The falcon snaps onto the control knob. Rotation and scrolling is fantastic. Moving the z height with this knob is much better than the stock knob. Plus it looks fantastic.
Print the control Knob upside down without supports. If you make supports getting them out of the center is nearly impossible. 100% infill - .15 layer height
Print the falcon separately with supports. Print it pointing up with a large brim (at least 5 mm). I used Slicr prusa edition and set the supports to 0 for auto. 100% infill - .15 layer height
The falcon snaps onto the control knob. Rotation and scrolling is fantastic. Moving the z height with this knob is much better than the stock knob. Plus it looks fantastic.
|
共0个文件
压缩包大小：227KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付