刺痛克隆 （普达 240） 三轴飞行器模式

Custom Parts for my stingy clone to tricopter conveion. 3 parts are included:
1) the tail plate: this plate holds the tail arm inline and sandwiches between the two bottom plates where the two rear arms normally would. Some very slight modification was needed, but I likely won't edit it unless I need a replacement or someone specifically asks.
2) Arm Protecto: These are simple remixes of to allow for M2 screws on the moto I used rather than the normal M3 screws.
3) Tilt Mechanism: This is another remix, in this case of My veion screws to the arm at the motor mounts, then gets held with the servo zip ties at the front. I included the 1808 motor veion (M2 screws) and the standard (M3) veion