Flashforge New Adventurer 3和Lite的外部灯丝模型

The Coupler will help you run a short length of PTFE tube from iide the filament compartment through to the exterior and aloo you to print 3rd party filaments on large spools without having to leave the compartment door open.
Add your 4mm diameter PTFE tube to this coupler and set to the filament compartment with you would like to guild the filament without having to leave the compartment door open, you have to make a hole for PTFE tube.
在Adventur3中，用于将第三方制的灯丝从外面拉入的导向部件。
安装方法
①将特氟隆软管切成10cm左右

②在导向部件上安装特氟隆软管
③使用灯丝输送部件的螺丝安装引导部件。
③在Adventur3的灯丝安装罩上打洞
④将特氟隆软管从孔中取出
这样，即使不打开盖子，也能通过特氟隆软管拉入细丝。向导零件和特氟隆软管没有使用粘合剂等，但是因为相当紧所以没关系。在意的人请用PPX粘合剂等固定。