发布时间：2024/11/5 10:10:00
The height of aluminum heat sink is 11.00 mm.
I tried to mount the heat sink on a Nema 17 stepper motor using two M3 bolts but it did not work. The heat sink needs at least three M3 holes to itall it properly.
The mount has two M3 set screw or bolt holes to secure the heat sink.
Applying thermal paste on back of the heat sink might provide enough adhesion between the heat sink and the stepper motor.
I tried to mount the heat sink on a Nema 17 stepper motor using two M3 bolts but it did not work. The heat sink needs at least three M3 holes to itall it properly.
The mount has two M3 set screw or bolt holes to secure the heat sink.
Applying thermal paste on back of the heat sink might provide enough adhesion between the heat sink and the stepper motor.
|
共个文件
压缩包大小：182KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付