发布时间：2024/1/10 15:36:00
the mount is a remix from iSheeZ here on thingivee
i liked the design but where the runcam split was mounted was not so great for the air flow so a re-engineered the hole mount from scratch
you will need
2x m3 18mm split board
2x m3 8mm split board
2x m3 nuts lid
2x m3 10mm tilt mount
2x 12g servo ( Im using one es09md that is modded with 2 3k ohm resistor to get a 180degree turn )
and 1 generic servo for the tilt mount
.
.
.
.
.
.
..
.
.
..
To all that will test this setup.. i my self i having some interference from the split board to the GPS there is some information on forum at RC groups on this.. i will test to shield of the borad with copper tejp on the iide of the mounting hole for the split bored will try to test it out ASAP and give you the result
i liked the design but where the runcam split was mounted was not so great for the air flow so a re-engineered the hole mount from scratch
you will need
2x m3 18mm split board
2x m3 8mm split board
2x m3 nuts lid
2x m3 10mm tilt mount
2x 12g servo ( Im using one es09md that is modded with 2 3k ohm resistor to get a 180degree turn )
and 1 generic servo for the tilt mount
.
.
.
.
.
.
..
.
.
..
To all that will test this setup.. i my self i having some interference from the split board to the GPS there is some information on forum at RC groups on this.. i will test to shield of the borad with copper tejp on the iide of the mounting hole for the split bored will try to test it out ASAP and give you the result
|
共个文件
压缩包大小：3MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付