发布时间：2024/10/19 16:56:00
Boba Fett stencil I made to hang my fire extinguisher in my woodshop.
At 100% it's about 110cm tall, so I've split it in 11 pieces ( the logo) that fit on my 30cmX30cm bed. Then by grouping them in Cura, I've managed to make 6 gcode.
I've included 2 full STL if you want to modify them, one split and one in one piece. The logo has little bridges ti help positioning, but the spray paint easily go under them.
My print settings :
0.28mm layer height
2 laye. No need for more! (except for the logo, you'll need more because of the bridges)
Of coue, no raft, no brim, no support :)
Video of the project here :
Made with Photoshop, Vector Magic, and 3d builder.
At 100% it's about 110cm tall, so I've split it in 11 pieces ( the logo) that fit on my 30cmX30cm bed. Then by grouping them in Cura, I've managed to make 6 gcode.
I've included 2 full STL if you want to modify them, one split and one in one piece. The logo has little bridges ti help positioning, but the spray paint easily go under them.
My print settings :
0.28mm layer height
2 laye. No need for more! (except for the logo, you'll need more because of the bridges)
Of coue, no raft, no brim, no support :)
Video of the project here :
Made with Photoshop, Vector Magic, and 3d builder.
|
共个文件
压缩包大小：2MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付