发布时间：2024/2/19 3:17:00
This is a rubber bushing that goes on the firewall of a Merkur Scorpio. The steering column goes through it.
This may also work with XR4Ti and other Ford SIerra derivatives.
If you is perished like mine was then you will notice that your steering wheel will feel very sloppy and the steering comfort adjustment will not work well.
Print this in 85-90 durometer polyurethane filament. You will have to use supports and do some minor cleanup of the part after printing.
You will have to disassemble the top flex joint to get this on. Apply silicone grease to help slip it into place in the sheet metal hole. Your are then back to Scorpio Bliss...
Dimeio were pulled from what remained of my original bushing.
This may also work with XR4Ti and other Ford SIerra derivatives.
If you is perished like mine was then you will notice that your steering wheel will feel very sloppy and the steering comfort adjustment will not work well.
Print this in 85-90 durometer polyurethane filament. You will have to use supports and do some minor cleanup of the part after printing.
You will have to disassemble the top flex joint to get this on. Apply silicone grease to help slip it into place in the sheet metal hole. Your are then back to Scorpio Bliss...
Dimeio were pulled from what remained of my original bushing.
|
共个文件
压缩包大小：104KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付