发布时间：2024/1/11 20:20:00
Bondtech e3D v6 direct drive mount for my Ender 5 that would work with the popular ABL seo (BLTouch, EZABL, etc) and a 5015 part cooling fan.
This should also work on the Ender 3 and CR10, but I haven't tested it.
Sources:
CR-10 Heavy Duty customisable modular e3D V6 mount Volcano 5015 ABL by chito:
With this mount you should be able to run any of the modular accessory mounts from chito's original files. I am currently running the 40mm fan mount with a Noctua 40x20mm fan, BLTouch on the left, and a 5015 fan on the right.
Bondtech BMG e3D V6 print head for Creality CR-10(S) by Greg191134:
I've included the stepper motor mount I'm using. I'm planning on changing this a bit in the future to include cable management on both sides of the bracket.
Future Additio:
I'm working on the following and will add once complete...
A Y-axis limit switch mount to use if wanting to retain Y-Axis build volume on the Ender 5.
A remix of the stepper motor bracket that adds cable management on both sides.
This should also work on the Ender 3 and CR10, but I haven't tested it.
Sources:
CR-10 Heavy Duty customisable modular e3D V6 mount Volcano 5015 ABL by chito:
With this mount you should be able to run any of the modular accessory mounts from chito's original files. I am currently running the 40mm fan mount with a Noctua 40x20mm fan, BLTouch on the left, and a 5015 fan on the right.
Bondtech BMG e3D V6 print head for Creality CR-10(S) by Greg191134:
I've included the stepper motor mount I'm using. I'm planning on changing this a bit in the future to include cable management on both sides of the bracket.
Future Additio:
I'm working on the following and will add once complete...
A Y-axis limit switch mount to use if wanting to retain Y-Axis build volume on the Ender 5.
A remix of the stepper motor bracket that adds cable management on both sides.
|
共个文件
压缩包大小：388KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付