发布时间：2024/3/10 6:43:00
made a base for hikvision colorvu camera
printed at 60c bed, 210 nozzel in pla, 0.2mm layer height, 4 walls thick, 40% infill, print with the 6 holes facing down to bed and supports from bed which will support the top ring part
the holes for the screws are 5mm wide and will need m4 threaded ierts pushing in with solding iron in order to screw the camera to the mount.
it has cable entry hole which can go top or bottom and it also has 2 drip holes so it doesnt matter which way it goes so the water if it gets in can drain out
it sits much flusher at 29mm to the wall compared to the ones in the shops allows solid wall mounting and thernet cable fits into the iide of the mount to protect from the elements
printed at 60c bed, 210 nozzel in pla, 0.2mm layer height, 4 walls thick, 40% infill, print with the 6 holes facing down to bed and supports from bed which will support the top ring part
the holes for the screws are 5mm wide and will need m4 threaded ierts pushing in with solding iron in order to screw the camera to the mount.
it has cable entry hole which can go top or bottom and it also has 2 drip holes so it doesnt matter which way it goes so the water if it gets in can drain out
it sits much flusher at 29mm to the wall compared to the ones in the shops allows solid wall mounting and thernet cable fits into the iide of the mount to protect from the elements
|
共个文件
压缩包大小：523KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付