发布时间：2024/9/1 16:49:00
2.设计用于减少Hellbot Magna（或Geeetech A10米）斗篷风扇（工厂）摄取的损失和通过覆盖离心风扇叶片的摄取改善其尾部通量的两件物品，球迷角度的改变，以改善流量方向和嵌入式喷嘴——其形状与原来的相似，因为经过测试，我不能提高更多的性能。
原覆盖范围内有四个螺丝可以固定部件，但有七个螺丝可以更好地固定。
这一结果是众所周知的，但只有在不打算采购规格更高的风扇的情况下才是可取的。
2 Pieces designed in order to reduce losses in the default layer fan of the geeetech A10M printer and to improve the airflow at the end of it by a new air inlet which cover the centrifugal fan blades，an Angle change of the whole fan and an incorporated nozzle-designed similarly to the original，I could not improve it much more after some research-.
它可能是固定的意大利他们与四个原始的screws despite it was designed for seven of them.
You will notice an improved airflow at the end the fan nozzle but is only recommendable to print this upgrade if you are not looking to buy a fan with better specs.
原覆盖范围内有四个螺丝可以固定部件，但有七个螺丝可以更好地固定。
这一结果是众所周知的，但只有在不打算采购规格更高的风扇的情况下才是可取的。
2 Pieces designed in order to reduce losses in the default layer fan of the geeetech A10M printer and to improve the airflow at the end of it by a new air inlet which cover the centrifugal fan blades，an Angle change of the whole fan and an incorporated nozzle-designed similarly to the original，I could not improve it much more after some research-.
它可能是固定的意大利他们与四个原始的screws despite it was designed for seven of them.
You will notice an improved airflow at the end the fan nozzle but is only recommendable to print this upgrade if you are not looking to buy a fan with better specs.
|
共个文件
压缩包大小：8MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付