发布时间：2024/2/19 17:29:00
“Flying Bear Ghost 4s”印刷头，两个涡轮增压4020。
打印所有的细节与ABS，100%的填充，比例为102%。
张力和着陆位置需要用易滑锉加工。拉紧使用螺母m3和螺栓3x30。
轴承原装紧固，力轻，有锁环槽，但我很好，没有他们。
涡轮风扇和板需要用螺丝钉，我买了3x30和减少到所需的长度。
Printhead for Flying Bear Ghost 4s with two 4020 turbo blowe.
Printed all parts with ABS，100%coverage，102%scale.
该teioner and the seat for it must be filed for easy the teioner，an m3 nut and a 3x30 bolt are used.
The original bearings are pressed with light effort，groves are provided for the retining rings，but I hold very well even without them.
turbine fan and the board need to be screwed on，I bought 3x30 and shortened to the desired length.
打印所有的细节与ABS，100%的填充，比例为102%。
张力和着陆位置需要用易滑锉加工。拉紧使用螺母m3和螺栓3x30。
轴承原装紧固，力轻，有锁环槽，但我很好，没有他们。
涡轮风扇和板需要用螺丝钉，我买了3x30和减少到所需的长度。
Printhead for Flying Bear Ghost 4s with two 4020 turbo blowe.
Printed all parts with ABS，100%coverage，102%scale.
该teioner and the seat for it must be filed for easy the teioner，an m3 nut and a 3x30 bolt are used.
The original bearings are pressed with light effort，groves are provided for the retining rings，but I hold very well even without them.
turbine fan and the board need to be screwed on，I bought 3x30 and shortened to the desired length.
|
共个文件
压缩包大小：4MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付