发布时间：2024/12/25 3:45:00
This type of enclosure is built around Heltec CubeCell-GPS LoRaWAN G tracker board.
SoftRF is an open project (GNU GPL) of aircraft collision avoidance avionics.
SoftRF is compatible with four most common ISM band aircraft collision avoidance protocols:
"Air V6" ;
OGN tracker ;
PilotAware ;
FANET (Skytraxx).
Website:
There are three variants of main Body part:
with no pin header access (-NPH file name suffix)
with partial pin header (-PPH suffix)
with full pin header access (-FPH)
The enclosure is designed to fit a 44 x 22 x 6 mm 600 mAh Li-Po battery.
If you are unable to print these parts by youelf - you may coider to find an appropriate local 3D service provider and place an order with assistance of Treatstock or 3DHubs portals.
SoftRF is an open project (GNU GPL) of aircraft collision avoidance avionics.
SoftRF is compatible with four most common ISM band aircraft collision avoidance protocols:
"Air V6" ;
OGN tracker ;
PilotAware ;
FANET (Skytraxx).
Website:
There are three variants of main Body part:
with no pin header access (-NPH file name suffix)
with partial pin header (-PPH suffix)
with full pin header access (-FPH)
The enclosure is designed to fit a 44 x 22 x 6 mm 600 mAh Li-Po battery.
If you are unable to print these parts by youelf - you may coider to find an appropriate local 3D service provider and place an order with assistance of Treatstock or 3DHubs portals.
|
共个文件
压缩包大小：272KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付