发布时间：2024/10/18 17:51:00
Remix from
This is to replace the need to buy the small table in the remixed veion, which also mea no need to hollow those legs. Combined the bracket and the extender along with the actual extra leg. Modified the bracket and the extender since it's merged to the new leg.
Currently, the leg is at 25cm which fits my CR-10S perfectly for a total height of 65cm.
Should you need a different length, you can just increase the height or message me and i can produce different lengths if needed
Highly recommending printing with 100% infill, you won't save much but not doing so. Might as well get a solid build.
I'd go with 0.32 resolution
This is to replace the need to buy the small table in the remixed veion, which also mea no need to hollow those legs. Combined the bracket and the extender along with the actual extra leg. Modified the bracket and the extender since it's merged to the new leg.
Currently, the leg is at 25cm which fits my CR-10S perfectly for a total height of 65cm.
Should you need a different length, you can just increase the height or message me and i can produce different lengths if needed
Highly recommending printing with 100% infill, you won't save much but not doing so. Might as well get a solid build.
I'd go with 0.32 resolution
|
共个文件
压缩包大小：219KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付