发布时间：2024/1/1 13:44:00
Simple mount I made to keep the hue dimmer switch under my desk.
Make sure to put a pause in the print so you can iert the magnet (8mmx5mm).
*Keep an eye on the layer after ierting the magnet, just to be sure it cove properly and doesn't hit. I didn't have problems but just in case.
Make sure to put a pause in the print so you can iert the magnet (8mmx5mm).
*Keep an eye on the layer after ierting the magnet, just to be sure it cove properly and doesn't hit. I didn't have problems but just in case.
|
共个文件
压缩包大小：218KB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付