发布时间：2024/2/3 0:20:00
Edit 2/28/2018: Added two new veio which are different, smaller sizes.
Tall and Grande.
Tall: 172mm
Grande: 180mm
Regular: 210mm
If you're really looking to print the regular and you have an Mp/Wanhao i3, use these:
(extender for front braces)
(extender with rear braces)
This is a gravity bong for people who want a more permanent gravity bong which prevents your house from looking like a trash keep. I can't stress enough to use PLA. It's made out of plants, not tar.
I believe this is the world's fit 3d printable gravity bong but I am not certain.
This is the fit model I've ever designed.
Here is a working stem:
Stem is 9mm
Here's everything :
For this model
-Cover mouth piece with hand, submerged, light and slowly lift up to draw smoke into chamber. You don't need a flame for more than a couple seconds to get it ember. Do not pull out of water at all during this. No danger, you'll just lose your smoke.
-Remove stem and cover hole with thumb. Use mouth piece to inhale smoke as you descend the bong back into the water. Cough and enjoy.
Edit: Slightly altered the air paths so it functio better. Mostly the same but made the base perimeter a tiny bit more flat. Edit 2: Added an alternate veion with a handle.
Tall and Grande.
Tall: 172mm
Grande: 180mm
Regular: 210mm
If you're really looking to print the regular and you have an Mp/Wanhao i3, use these:
(extender for front braces)
(extender with rear braces)
This is a gravity bong for people who want a more permanent gravity bong which prevents your house from looking like a trash keep. I can't stress enough to use PLA. It's made out of plants, not tar.
I believe this is the world's fit 3d printable gravity bong but I am not certain.
This is the fit model I've ever designed.
Here is a working stem:
Stem is 9mm
Here's everything :
For this model
-Cover mouth piece with hand, submerged, light and slowly lift up to draw smoke into chamber. You don't need a flame for more than a couple seconds to get it ember. Do not pull out of water at all during this. No danger, you'll just lose your smoke.
-Remove stem and cover hole with thumb. Use mouth piece to inhale smoke as you descend the bong back into the water. Cough and enjoy.
Edit: Slightly altered the air paths so it functio better. Mostly the same but made the base perimeter a tiny bit more flat. Edit 2: Added an alternate veion with a handle.
|
共个文件
压缩包大小：1MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付