发布时间：2024/1/8 19:38:00
A quick way to swap out the steering wheel on Fanatec's Univeal Hub.
I originally was going to print this from ABS for strength. The prototype I did in PLA was plenty strong enough. Used a filament runout swap for the colour change on the logo.
It may be strong enough without the M4 x 20 bolts but I added these for extra strength. If anyone uses it without and it tur out to be strong enough I could upload a solid veion without the screw holes.
UPDATE
V6 Thinner Veion added with improved logo. (Note: shorter bolts)
UPDATE
V10 Thinner Veion with longer thread for centre nut & nut to suit. Also slight reduce tolerance in 3 mounting holes and a spannewrench to tighten the centre nut.
I originally was going to print this from ABS for strength. The prototype I did in PLA was plenty strong enough. Used a filament runout swap for the colour change on the logo.
It may be strong enough without the M4 x 20 bolts but I added these for extra strength. If anyone uses it without and it tur out to be strong enough I could upload a solid veion without the screw holes.
UPDATE
V6 Thinner Veion added with improved logo. (Note: shorter bolts)
UPDATE
V10 Thinner Veion with longer thread for centre nut & nut to suit. Also slight reduce tolerance in 3 mounting holes and a spannewrench to tighten the centre nut.
|
共个文件
压缩包大小：13MB
|
||
|---|---|---|
微信小程序
微信扫码打开此模型
迪威模型
微信扫码支付