修改

图片

迪威模型和Solidworks 联合会员
迪威网友e1def3
迪威网友e1def3

DJI Mavic控制器和iPad支架

免费,登录即可下载
发布时间:2021/2/3 15:18:00
As great as the DJI Mavic drone is, the controller is designed to only hold a smart phone or a small tablet. I have the iPad Air 2 and the view is so much better that I wanted to use it itead of my iPhone. There are iPad holde on the market, but you need to hold them up and can’t easily use neck straps. Just the controller and iPad weigh almost two pounds and it gets heavy holding them out in front of you while flying. If you use a neck strap, it will block the iPad which defeats the whole point in using it.
This design solves these problems by using one part to hold the iPad and the controller and another part to guide and restrain the straps agait your chest. Even if you let go of the controller, everything stays in place. Also the base part hooks over the lip under the controller display for more stability. There is a 10 degree back tilt on the iPad and controller for the optimum viewing angle. And you can use a suhade on the iPad as long as it fits iide the G10 mount.
I found a couple of straps from camera and computer bags that fit nicely in this holder. A wide, padded one is best to distribute the weight across your neck.
Because this holder is made in two parts, it is easily collapsed for traveling. I used the 1/4-20 standard for all the hardware so that extra nuts and washe would work in both places.
Here is the bill of materials:
1) iShot G10 Pro Univeal iPad Tablet Tripod Mount
2) One 1/4-20 threaded rod 70mm (2.75”) long
3) One 1/4-20 x 1 in machine bolt
4) Three 1/4 in flat washe
5) Two 1/4-20 wing nuts
I suggest packing spare hardware in case something is misplaced.
0个文件
压缩包大小:3MB
小程序二维码
微信小程序 微信扫码打开此模型
登录后发表评论
恒诺鑫科-专注碳素制品的开发与生产