模型说明
Widened the center of the pulley a little bit and rounded the edges to give it a 'fatter' look. This will mount fine in the original creato bracket, as well as in the alternative bracket I remixed. The diameter for the pin to attach the pulley to the bracket is also unchanged.
Extruder Temp: 200
Bed Temp: 62
Speed: 60mm
Fan: 90%
I used a brim since there was not a lot of contact between the pulley and build plate, so I did have to lightly file some minor edges off. I am not certain it was required.
Extruder Temp: 200
Bed Temp: 62
Speed: 60mm
Fan: 90%
I used a brim since there was not a lot of contact between the pulley and build plate, so I did have to lightly file some minor edges off. I am not certain it was required.
评论