模型说明
I designed this to use an axis from my saitek quadrant to control flaps on the PMDG 737 NGX, there are the 9 flaps positio (using the idle button for flaps full).
You need to cut to plastic part that prevent the blue lever to slide freely, you can then need to put a screw on the lever's arm (I used a wood screw) and use a spring going trough the 3D printed lever part and attached to that screw. Now you just need to lift the lever to change flaps position like on the real B737.
I used fsuipc to setup the flaps, you need to modify the max value of the axis to 20000 (default around 163384) so that the end ofthe axis stops at flaps 30.
Then setup the idle button for flaps max, and action when button release: flaps decr.
Let me know in the comments if there's any problem
You need to cut to plastic part that prevent the blue lever to slide freely, you can then need to put a screw on the lever's arm (I used a wood screw) and use a spring going trough the 3D printed lever part and attached to that screw. Now you just need to lift the lever to change flaps position like on the real B737.
I used fsuipc to setup the flaps, you need to modify the max value of the axis to 20000 (default around 163384) so that the end ofthe axis stops at flaps 30.
Then setup the idle button for flaps max, and action when button release: flaps decr.
Let me know in the comments if there's any problem
评论