模型说明
UPDATE:
Hello guys! I have my fit Kickstarter project running! Please check it out and share this link!https:www.kickstarter.com/projects/kenzoselleslaghs/rgb-touchpanel-for-micro-controller-s
Many thanks!
Hello guys
As promised
I did a remake of my old filament seor because there were to many parts, and it was heavy.
So this seor detects jams in the hotend also running out of filament.
It uses a seor and an arduino
How does it work?
filaments spi the toothed wheel in the seor, the seor goes high to low and vice vea. The arduino calculates if the time between HIGH and LOW is between the programmed time, if not the arduino pin will go high and sends a signal to your buzzer
(more info in the arduino sketch)
Use dark plastic for the toothed filament roller, i noticed if you use light plastic the seor readings where not reliable, so i covered the tooth with paint...
if the filament slips use double sided tape in the toothed roller, i made a litte notch in the roller so you can cut a piece of tape and paste it in the roller..
Did many tests with this one and it works like a charm!
BOM:
3x40mm M4 bolt nuts
1x10mm M3 nut
4x 624zz bearings
1x velocityseor (speedseor arduino)
1x arduino (or attiny if you know how to program it)
1x buzzer
BOM printable:
1x Body part
1x Body Cap
1x 2020 extrusion mount (tevo tarantula)
2x Filament guide roller
1x Filament toothed roller
Changelog imoprvements:
2 Part printable body
Get rid of the 608zz bearings i Changed the holes to fit 624zz bearings itead
Easier to itall
Hello guys! I have my fit Kickstarter project running! Please check it out and share this link!https:www.kickstarter.com/projects/kenzoselleslaghs/rgb-touchpanel-for-micro-controller-s
Many thanks!
Hello guys
As promised
I did a remake of my old filament seor because there were to many parts, and it was heavy.
So this seor detects jams in the hotend also running out of filament.
It uses a seor and an arduino
How does it work?
filaments spi the toothed wheel in the seor, the seor goes high to low and vice vea. The arduino calculates if the time between HIGH and LOW is between the programmed time, if not the arduino pin will go high and sends a signal to your buzzer
(more info in the arduino sketch)
Use dark plastic for the toothed filament roller, i noticed if you use light plastic the seor readings where not reliable, so i covered the tooth with paint...
if the filament slips use double sided tape in the toothed roller, i made a litte notch in the roller so you can cut a piece of tape and paste it in the roller..
Did many tests with this one and it works like a charm!
BOM:
3x40mm M4 bolt nuts
1x10mm M3 nut
4x 624zz bearings
1x velocityseor (speedseor arduino)
1x arduino (or attiny if you know how to program it)
1x buzzer
BOM printable:
1x Body part
1x Body Cap
1x 2020 extrusion mount (tevo tarantula)
2x Filament guide roller
1x Filament toothed roller
Changelog imoprvements:
2 Part printable body
Get rid of the 608zz bearings i Changed the holes to fit 624zz bearings itead
Easier to itall
评论