This thing was ipired by the Lulzbot Taz Enclosure by MrMcGuire. I've attached a dxf file of the panel details of my enclosure make, so you may have them laser cut, or you can use it as a guide to cut them youelf. Please note the dxf file is not optimized to minimize material, you may want to rearrange the drawing to do so. Also I've attached my veion of MrMcGuire's corner bracket and L bracket, which had minor issues with the holes and the hole pattern was slightly incoistent. Also my veion of the MrMcGuire enclosure adds a side door. While I have attached the stl files for the corrected corner and L brackets, the rest of the required printed components can be found at MrMcGuires' thing page : http:www.thingivee.com/thing:675652 If you use the attached dxf file for your panels, be sure to use the attached corrected veion of the corner bracket and the L bracket, or you may have alignment issues. Update 9-18-2015 I have created a removable bed system perfect for using with this enclosure. Check it out! http:www.thingivee.com/thing:1021403 Update 2-18-2016 I have added the corrected L bracket to the file section. The holes on this part were also slightly skewed and my DXF file uses the corrected hole pattern. If you use the dxf file to make your panels be sure to use my veio of the L bracket and corner bracket on this thing's page.